In Reply to: Re: 9N Timing procedure posted by TheOldHokie on December 03, 2013 at 09:47:23:
Hat's off to TOH for coming up with another great time saver! The best I could come up with was a 6" piece of 2x4, with a couple of dowel rods, and a slot for the tang. I could drop the distributor on the dowels, and turn the shaft until the tang dropped into the slot. It was a little better than the method in the manual, but far from ideal. I tossed my wooden jig in the burn pile as soon as I got one of these fine tools from TOH.
KL
Posting not permitted in the forum archives.<1386169232">