Re: Spindle bushing

In Reply to: Spindle bushing posted by DOUG on October 18, 2022 at 20:59:30:

The hole in the spindle housing is much to large causing the bushing to just fall in. No press fit at all. I suppose I will have to buy another housing. Thanks for the offer to come over and get a spindle off one of your machines, but kinda long drive from Georgia. The other side spindle bushings were a proper very tight press fit. Was just hoping someone would know of a good fix.

Follow Ups:

• Re: Spindle bushing - TheOldHokie 07:03:10 10/21/22 (0)
• Re: Spindle bushing (url) - Ed Gooding (VA) 04:43:08 10/21/22 (0)

Name   : 
E-Mail : 
Subject: 

Message:

To add a single image to your post,  click here.
To add multiple images to your post, click here.

Optional Link URL : ←http://www.yourwebsite.com
Link Title        : ←Website Title
Optional Image URL: ←http://www.myimages.com/mypic.jpg

Enter image characters into the text box.

Press Preview Message button below to proofread message & check if images and/or links are shown before posting message. Press browser's back button if correction is needed. Press Post Message button on Preview Message page to finalized your post. Thanks!