Re: Sleeve puller/installer

[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]
Posted by Mike Maiman on October 16, 2022 at 21:27:07 [URL] [DELETE] :

In Reply to: Sleeve puller/installer posted by Patricio de la Cuadra on October 16, 2022 at 20:25:36:

I recently rebuilt a '51 engine that had .090" sleeves installed that were worn and out of round. I bored and honed the old sleeves and installed new .040" oversize pistons and rings. That might be an option to consider.


Follow Ups:

Post a Followup: 
Name   : 
E-Mail : 
Subject: 

Message:

To add a single image to your post,  click here.
To add multiple images to your post, click here.

Optional Link URL : ←http://www.yourwebsite.com
Link Title        : ←Website Title
Optional Image URL: ←http://www.myimages.com/mypic.jpg
Enter image characters into the text box.

Press Preview Message button below to proofread message & check if images and/or links are shown before posting message. Press
browser's back button if correction is needed. Press Post Message button on Preview Message page to finalized your post. Thanks!
[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]