Re: donnahoo

[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]
Posted by JMOR on May 05, 2022 at 16:39:07 [URL] [DELETE] :

In Reply to: donnahoo posted by frank on May 03, 2022 at 17:43:24:

Can't determine from this thread if problem has been solved or not, but if not, bend float arms such that the same 0.25 inch clearance exist for the full length of float, NOT just at one end.


Follow Ups:

Post a Followup: 
Name   : 
E-Mail : 
Subject: 

Message:

To add a single image to your post,  click here.
To add multiple images to your post, click here.

Optional Link URL : ←http://www.yourwebsite.com
Link Title        : ←Website Title
Optional Image URL: ←http://www.myimages.com/mypic.jpg
Enter image characters into the text box.

Press Preview Message button below to proofread message & check if images and/or links are shown before posting message. Press
browser's back button if correction is needed. Press Post Message button on Preview Message page to finalized your post. Thanks!
[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]