Attaching control valve fork

[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]

Posted by Tom on April 23, 2017 at 20:35:55 [URL] [DELETE] :

The hydraulics on my 40 9n would go up, but not down. Figured the bottom of the pump was full of sludge... it sure was. Removed the pump and cleaned it up in diesel fuel. went it reinstall but can't figure out out to reattach the control valve fork. I removed the inspection covers and tried to use a hand through each hole to reattach the fork, but after three hours haven't had any luck. Suggestions short of paying a child with small hands to get in there and reattach it. Do most people take off the top cover to do this?


Follow Ups:


Post a Followup:
Name   : 
E-Mail : 
Subject: 
Message: To add a single image to your post, click here. To add multiple images to your post, click here. Optional Link URL : http://www.yourwebsite.com Link Title : Website Title Optional Image URL: http://www.myimages.com/mypic.jpg
Enter image characters into the text box.

Press Preview Message button below to proofread message & check if images and/or links are shown before posting message. Press
browser's back button if correction is needed. Press Post Message button on Preview Message page to finalized your post. Thanks!
  
   

[ Follow Ups ] [ Post Followup ] [ N Board Forum ] [ FAQ ]