The four bolts holding the Drive Sheave to the Drive Shaft have sheared on my rake. To remove the sheared bolts I must remove the Drive Shaft. The Universal joint housing is pinned to the Drive Shaft using a Groove Pin per the parts list.
I carefully measured the both heads to assure I drove on the larger end. Drove it about .025 and the picture shows what I see on the other end.
It appears, once the Groove Pin had been inserted, they peaned the other end over. It also appears to me as if I am driving in the wrong direction.
Had anyone had any experience with this rake and can give me some advise. Certainly would be appreciated!