Re: Wanted: Distributor parts

[ Follow Ups ] [ Post Followup ] [ Ads Forum ] [ FAQ ]

Posted by Tim Daley(MI) on October 17, 2018 at 05:29:51 [URL] [DELETE] :

In Reply to: Re: Wanted: Distributor parts posted by K.LaRue-VA on October 16, 2018 at 10:52:45:

Just some friendly machining advice: The timing marks are usually knurled, but I suspect these parts were stamped special after the radius was formed. They were probably stamped out by the thousands on a special stamping machine. If you put the marks on when it is flat, once the piece is bent, the marks will get deformed a bit and not necessarily true anymore. I can't say exactly how much they will deform, maybe not anything to be concerned with. Try a few samples and compare to an original. Like Dan said, not really used much anyway. I tried to use it once and ended up putting right back to where it was set. here's the deal. Somebody makes all of these parts. I don't know if new aftermarket units even have them. They just don't sell them all individually. Same with some carb parts. Kits don't have some of the finer brass jet screws and plugs but they are on new units.

Tim Daley(MI)


Follow Ups:


Post a Followup:
Name   : 
E-Mail : 
Subject: 
Message: To add a single image to your post, click here. To add multiple images to your post, click here. Optional Link URL : http://www.yourwebsite.com Link Title : Website Title Optional Image URL: http://www.myimages.com/mypic.jpg
Enter image characters into the text box.

Press Preview Message button below to proofread message & check if images and/or links are shown before posting message. Press
browser's back button if correction is needed. Press Post Message button on Preview Message page to finalized your post. Thanks!
  
   

[ Follow Ups ] [ Post Followup ] [ Ads Forum ] [ FAQ ]